Safety Measures - Vitek VT-2230 Manual Instruction

HAIR STRAIGHTENER VT-2230
The unit is intended for hair straightening.
DESCRIPTION
1. Heating plates
2. Display
3. Heating plates temperature setting buttons «+/-»
4. On/Off button «
5. Hanging loop
6. Heating plates lock
ATTENTION!
Do not use this unit near containers filled with water (such
as a sink, bath etc.).
•
When using the unit in a bathroom, unplug it right
after usage by taking the power plug out of the mains
socket, as closeness of water is dangerous even if the
unit is switched off.
•
For additional protection you can install a residual cur-
rent device (RCD) with nominal operation current not
exceeding 30 mA into the bathroom mains; contact
a specialist for installation.
•
Place the hair straightener on a flat steady heat-
resistant surface. Make sure that the heating plates
and outer operating surfaces do not touch fusible and
inflammable objects (plastic, polyethylene, synthetic
materials etc.).

SAFETY MEASURES

Before using the electrical unit, read this instruction
manual carefully and keep it for future reference.
Use the unit for its intended purpose only, as specified
in this manual. Mishandling of the unit may lead to its
breakage and cause harm to the user or damage to his/
her property.
•
Before switching the unit on, make sure that voltage
of the mains corresponds to unit operating voltage.
•
Never leave the operating unit unattended.
•
Do not switch the unit on in places where aerosols are
sprayed or highly flammable liquids are used.
•
Hair spray should be applied only after hair straight-
ening is finished.
ENGLISH
»
3