Stanley FATMAX SFMCPS620 Instruction Manual page 10

English
To reduce your exposure to these chemicals, wear
approved safety equipment such as dust masks that are
specially designed to filter out microscopic particles.
Avoid prolonged contact with dust from power sanding,
•
sawing, grinding, drilling, and other construction
activities. Wear protective clothing and wash exposed
areas with soap and water. Allowing dust to get into your
mouth, eyes, or lay on the skin may promote absorption of
harmful chemicals.

WARNING: Use of this tool can generate and/
or disburse dust, which may cause serious and
permanent respiratory or other injury. Always use
approved respiratory protection appropriate for the dust
exposure. Direct particles away from face and body.

CAUTION: Wear appropriate personal hearing protection
during use. Under some conditions and duration of use,
noise from this product may contribute to hearing loss.
Before Operating Pole Saw
• For safe operation, read and understand all instructions
before using the pole saw. Follow all safety instructions.
Failure to follow all safety instructions listed below, can result
in serious personal injury.
• Watch what you are doing. Use common sense. Do not
operate pole saw when you are tired.
• Use pole saw for cutting tree branches only. Do not use
pole saw for purposes not intended. Do not use for cutting
other items.
• Only well-instructed adults should operate pole saw.
Never allow children to operate.
• Do not allow children or untrained individuals to use
this unit.
• Wear the following safety gear when operating pole saw:
ʵ heavy-duty gloves
ʵ steel-toed safety footwear with non-skid soles
ʵ safety glasses, goggles or face screen
ʵ safety hard hat
ʵ ear mufflers or ear plugs
ʵ face or dust mask (if working in dusty areas)
• Wear heavy long pants and boots. Do not wear loose
fitting clothing, short pants, jewelry of any kind, or go barefoot.
• Secure long hair so it is above shoulder level to prevent
entanglement in any moving parts.
• Before cutting, always provide the following:
ʵ clear work area
ʵ secure footing
ʵ planned retreat path from falling limbs
• Inspect tree before trimming. Make allowance for branches to
fall freely to the ground.
• Do not use your pole saw to fell saplings.
8
While Operating Pole Saw

DANGER: To reduce the risk of electric shock
do no use on wet surfaces. Do not expose to rain.
Store indoors.

DANGER: Avoid Unintentional Starting – with battery
installed, don't carry appliance with with finger on switch.
Be sure switch is off when installing battery.
• Stay alert. Use common sense while operating the unit.
• Keep work area clean. Cluttered areas invite injuries.
• Always remove battery from pole saw when finished cutting or
when left unattended.
• Keep children, animals and bystanders at least 15 m away
from pole saw. Only pole saw user should be in work area.
• Do not use the pole saw to cut down trees.
• Do not grasp the exposed saw chain when picking up or
holding the pole saw.
• Grip pole saw securely - one hand on the pole, the other on
the handle.
• Keep finger off trigger until ready to make cut.
• Before starting pole saw, make sure chain is not
touching anything.
• Keep all parts of body away from chain when pole saw
is running.
• Do not force pole saw while cutting. Apply light pressure.
It will do the job better and safer at the rate for which it
was intended.
• Carry pole saw from one place to another:
ʵ with battery removed,
ʵ fingers off/away from trigger,
ʵ by holding pole at balance point, and
ʵ with guide bar and chain to rear and with
scabbard attached.
• Do not cut small brush and saplings with the pole saw. Slender
matter may catch in the chain and be whipped toward you.
This could also pull you off balance.
• Do not operate in poor lighting.
• Keep firm footing and balance. Do not overreach.
Overreaching can result in loss of balance or exposure to
hot surfaces.
• Keep all parts of your body away from any moving part.
• Do not, under any circumstance, use any attachment or
accessory on this product, which was not provided with the
product, or identified as appropriate for use with this product
in this instruction manual.
• Inspect pole saw before each use and after dropping or other
impacts. Ensure there are no significant defects or damage.
Do Not Operate Pole Saw:
ʵ while under the influence of alcohol, medication, or drugs.
ʵ in rain or in damp or wet areas.
ʵ where highly flammable liquids or gases are present.
ʵ if pole saw is damaged, adjusted incorrectly, or not fully
and securely assembled.