Power Sprayer Handle Assy Installation - Peco PS5 Operator's Manual

Power Sprayer Handle Assembly Installation
Before installing the Power Sprayer Handle Assembly (Item #1), install (2) Locator Pin Nuts (Item #3) to either side of
the Chassis by using (2) 1/4"-20 x 1/2" HHCS (Item #4). See Figure A.
Once the Locator Pin Nuts have been installed, position the Chassis Brace (Item #2) between the Left & Right
Chassis as seen in Figure B. Align the Chassis Brace's bolt holes to those on the Left & Right Chassis keeping it
positioned in place by using (2) 5/16"-18 x 1-1/4" Carraige Bolts (Item #6).
When the Chassis Brace is in place, place (2) 5/16" Flat Washers (Item #5) over the Carriage Bolt on the outside of
the Chassis. Then Position the Power Sprayer Handle Assembly (Item #1) over Flat Washer and Carriage Bolt.
Secure the Power Sprayer Handle Assembly by using (2) Wing Knobs (Item #7). Refer to Figure B below.
Note: Some parts and part features have been hidden from view for visual clarity.
Figure A Figure B
8