Table of Contents
Advertisement
OPERATING INSTRUCTIONS III
1. After flipping the switch into the ON position, squeeze
wand handle to allow air pressure in hose to be
released (make sure the strainer is completely
submerged).
2. Hold wand handle until liquid begins to flow and all air
bubbles are out of the hose.
3. Always turn the sprayer off before re-filling the
container.
Be sure to loosen or remove the vent cap from the
smaller tank opening to avoid creation of a vacuum
inside of tank.
A unit that has been used with herbicides should never
be used to spray insecticides, unless the sprayer has
been properly cleaned and all other chemicals
neutralized. Failure to do this could cause you to kill
plants that have been sprayed. Consult with the
manufacturer of the chemicals in sue to obtain proper
instructions.
BATTERY & CHARGER INFORMATION
Fully Charge Before First-Time Usage:
* Plug Charger into wall socket and plug opposite
connecting end into Sprayer to begin battery charging.
* Notice a "Green" & "Red" light located on Charger.
* Once correctly plugged in, a steady "Red" light
designates battery charging and a steady "Green" light
designates battery charged.
* Leave charger connected until a steady "Green" light is
achieved before using sprayer.
The new battery charging system eliminates user error
and will automatically stop charging once a full charge is
detected. Battery charging time will vary depending on
power level remaining in battery. The battery will last up
to 5 hours in between full charges. Only use charger
provided to prevent overheating and permanent damage
to the battery.
The battery life span is approximately 200 charges.
DOCUMENT THE FOLLOWING INFORMATION FOR FUTURE REFERENCE
Unit Model Number:_______________________________________________
Unit Serial Number:________________________________________________
Date of purchase:________/________/_________
Dealer/Distributor Name:__________________________________________
Address: _________________________________ State:_______ Zip:_______
Phone Number: ____________________________________________________
SPRAYER CARE
A. This sprayer is made of the most chemical resistant
materials available, but care must be taken to ensure
product longevity. Immediate cleaning and proper
maintenance after each use will eliminate most
sprayer failures.
B. Many chemicals can deteriorate pump parts if not
rinsed clean after each use. Which solution you use
will depend on the pesticides used. Always check the
pesticide label for cleaning instructions.
C. Clean pump thoroughly with a cleaning solution for 3
minutes. Rinse with clean soapy water for 2 minutes
to remove cleaning solution.
* DO NOT USE BLEACH SOLUTION OR HIGHLY
FLAMMABLE LIQUIDS SUCH AS GASOLINE
OR PAINT THINNER IN SPRAYER.
D. Soluble powders and diluted liquids may be used in
the sprayer. Wet powder solutions tend to come out
of solution, coating the inside of the pump. Wet
powders must be washed out very thoroughly. Over a
period of time, most chemicals will separate and
cause a build up in the pump. Chemicals are
absorbed by the plastic hoses and cannot be rinsed
out after extended periods of time.
E. Rinse thoroughly after each use.
STORAGE
Special care should be taken before storage of the
sprayer. Fully re-charge the battery. Thoroughly rinse
the pump, hoses and container with clean, soapy water.
Do NOT store sprayer with the pump pressurized or with
spray solution in the tank.
PARTS AND SERVICE
INFORMATION IV
PECO Power Sprayer owners should record the name
and telephone number of their Service Center. Your
Service Center will be happy to supply replacement
parts, accessories, and do any service or repairs to your
PECO Power Sprayer. If for any reason your Service
Center is unable to service your PECO Power Sprayer
or supply replacement parts, contact PECO and include
the following information on the chart below.
2021 (v1.0)
17
Advertisement
Table of Contents
