Verifying Inverter Software Version; Set Inverter Grid Compliance (Optional); Proof Of Compliance - Generac Power Systems XVT076A03 Installation And Owner's Manual

Commissioning
•
Zero Import. CRD200 Export Only compliance to
remove the ability of the battery to charge from the
grid. See Zero Import.

Verifying Inverter Software Version

Some features, such as those found in
Export Compliance (optional), require inverter software
that may not come default to the unit installed. The soft-
ware version of an inverter can be verified using the
Installer Configuration Tool. To verify the inverter soft-
ware version in the Installer Configuration Tool, select the
'Common' submenu option under the "Inverter" object as
shown in Figure 6-27.
Figure 6-27. Verifying Inverter Software
The information populated upon selecting the 'Common'
sub-menu option lists the manufacturer, model, version,
and serial number for the inverter. The value displayed
for 'Version' contains the hardware version and software
version of the inverter displayed as the sequence of num-
bers separated by an underscore. Where an "H" rep-
resents the hardware version and an "S" represents the
software version, the value shown for 'Version' would be
"HHH_SSSSS".
Set Inverter Grid Compliance
(optional)
NOTE: The inverter must be disabled before changing
utility compliance settings. Before disabling the inverter,
ensure all REbus devices have first been disabled. Com-
pliance settings changes will not be applied if the inverter
is enabled.
By default, all Generac PWRcell Inverters ship in compli-
ance with IEEE 1547 to meet UL 1741. If the system
needs to be configured to comply with a different grid
interconnection standard, activate the new configuration
via the Installer Configuration Tool. See
Configuration Tool (optional)
1. To set an inverter to comply with a utility's require-
ments, navigate to the drop-down menu in the
upper right-hand corner of the Installer Configura-
tion Tool home page and select Inverter from the
drop-down menu.
2. See Click on Utility Compliance Con-
Figure 6-28
figuration and select the appropriate utility compli-
34
Set Import /
011233
Access Installer
for more information.
ance standard from the menu at the bottom of the
page. Click Submit to apply the compliance stan-
dard. The settings entered will not take effect until
the Submit button has been clicked.
Figure 6-28. Utility Compliance Configuration
NOTE: Verify the Compliance Selection field shows the
desired compliance rule after clicking Submit.
NOTE: For multi-system sites, compliance must be set
on each inverter separately through each respective Bea-
con.

Proof of Compliance

See 6-29. The Compliance PDF validates
Figure
whether the system has been set up to conform to a util-
ity compliance ruleset. Please double check that the sys-
tem is configured properly by observing the 'In
compliance with' line in the PDF. If the utility requires
proof of correct configuration, save this PDF and send it
to the utility. It is recommend to keep a copy on file as
well.
1. To generate a proof of compliance PDF, click on
the Compliance PDF tab in the navigation menu.
2. Click on Download Report.
3. A new window will open in the browser with the
report. Verify the information is correct and save
the document or send via email.
Installation and Owner's Manual for Generac PWRCell Inverter
010983