Generac Power Systems XVT076A03 Installation And Owner's Manual page 34

Commissioning
2. See
Figure 6-12. Use the up and down arrows to
highlight Mod. Settings and press the center button
to enter the settings menu.
REbus Beacon
Enable
Mod. Settings
Remove Device
RCPn: 00010012XXXX
< EXIT SCROLL > NEXT • SELECT
Figure 6-12. Configuring TOU Schedule (2 of 4)
3. See Figure 6-13. Use the up and down arrows to
highlight Access Code and press the center button
to select.
4. Use the up and down arrows to set the Access
Code to 57, and press the center button.
NOTE: The access code is valid for five minutes. After
five minutes, the access code must be entered again to
enable changes.
Access Code:
TOU Schedule:
Time Zone:
Cancel
Figure 6-13. Configuring TOU Schedule (3 of 4)
5. Use the up and down arrows to highlight TOU
Schedule and press the center button to select.
6. Use the up and down arrows to adjust the TOU
Schedule code. Once the desired value is set,
press the center button to exit edit mode.
NOTE: See the latest Time of Use Program Guide for
current TOU schedule values. The program guide is
https://www.generac.com/resources-and-
available at
tools/ce-installer-resources/installation-resources.
7. Set the Time Zone to the desired location based on
Table 6-3: Time Zone
value is set, press the center button to exit edit
mode.
30
Menu
012452
57
1
4
Save
010111
Codes. Once the desired
Table 6-3. Time Zone Codes
Time Zone
UTC
US / Eastern
US / Central
US / Mountain
US / Pacific
US / Alaska
US / Hawaii
US / Arizona
US / Puerto Rico
8. See Figure 6-14. To commit changes to all entries,
highlight Save and press the center button.
Access Code:
TOU Schedule:
Time Zone:
Cancel
Figure 6-14. Configuring TOU Schedule (4 of 4)
See Figure 6-15 and Figure
LCD will alternate between a TOU Scheduler Running
Screen and a Current System Mode screen. Both
screens will display the time until the next system change
and the mode the system will change to. The TOU
Schedule name will be listed at the bottom of the device
page.
REbus Beacon
TOU Scheduler
running
Next Change:
To:
Schedule:
Figure 6-15. Running.
Installation and Owner's Manual for Generac PWRCell Inverter
Units
0
1
2
3
4
5
6
7
8
57
1
4
Save
010112
6-16. When enabled, the
1h:37m
Self Supply
SDGE
010113