How To Access The Installer Configuration Tool; Configuring Basic Pwrcell Settings - Generac Power Systems XVT076A03 Installation And Owner's Manual

NOTE: All PWRcell Inverters come with a REbus Bea-
con pre-installed.

How to Access the Installer Configuration Tool

1. Navigate to the Beacon device page on the PWR-
cell Inverter control screen and press the center
button.
2. Select Installer Tool from the menu and click Con-
firm. This will activate the Beacon's Wi-Fi network.
3. Use a smartphone or laptop to connect to the Wi-Fi
network SSID titled: REbus_Beacon_xxxx where
xxxx is the last 4 digits of the Beacon's RCP num-
ber.
NOTE: The Beacon's RCP number can be found on the
front of the Beacon located inside the inverter, as well as
on the Beacon device page through the inverter's screen.
To find this number through the inverter's screen press
the center button on the Beacon device page. The RCP
number will be displayed at the bottom of the menu
screen.
4. Type in the password (labeled "CODE") for the
REbus Beacon's Wi-Fi network.
NOTE: The code for the REbus Beacon's Wi-Fi network
is located on the back of the Beacon inside of the
inverter. The Beacon is mounted on the upper left-hand
sidewall of the inverter housing. Unstick the Beacon to
view the code labeled on the back.
NOTE: Where utility requirements contain provisions for
security against adjusting compliance settings, consider
removing code label for the Beacon after successful
commissioning.
5. See 6-25. Open a web browser on a smart-
Figure
phone or laptop and enter 10.10.10.10 for the
browser URL. The installer tool will appear in the
browser.
Figure 6-25. Installer Configuration Tool
Installation and Owner's Manual for Generac PWRCell Inverter

Configuring Basic PWRcell Settings

NOTE: To customize basic settings, the inverter must be
disabled. Before disabling the inverter, ensure all REbus
devices have first been disabled. Settings changes will
not be applied if the inverter is enabled.
1. Select Inverter from the menu.
NOTE: If using a smartphone, open the menu by click-
ing the hamburger icon in the upper-right corner of the
screen. Laptop users will see the menu displayed on the
left side of the screen.
2. Select PWRcell Configuration.
3. See
Figure
select the desired change, and click Submit. Any
changes selected to be made, will not be imple-
mented unless Submit is selected at the end.
Figure 6-26. PWRcell Configuration
Most device settings can be adjusted through the
inverter's screen with the exception of the following set-
tings, which can only be adjusted though the Installer
Configuration Tool:
•
Enabled SysModes. Allows installers the option to
disable system modes, such that they cannot be
enabled through the inverter control screen. To dis-
able a system mode, tap the checkbox to uncheck
the box for that mode. Click Submit to save.
•
Clear Display. Allows installers to wipe the screen
of any unwanted devices being retained by the
memory card in the screen module. Select Clear
and click Submit. The screen will go blank and test
its LEDs. Allow time for the screen to reload before
accessing.
•
Export Limiting. CRD200 Import Only compliance
to limit export or achieve zero export. See
Limit.
010981
Commissioning
6-26. To adjust a setting, click on it,
010982
Export
33