Preparation Before Operation - Mitsubishi Electric MSZ-WG20VA-H1 Operating And Installing Instructions

Preparation before operation

Remote controller
Transmitter section
Operation display
section
Operate/stop
(ON/OFF) button
Fan speed control button
Operation select button
Econo Cool button
Wide vane button
(Vertical vane button)
Long operation
MOVE EYE button
Reset button
Remove the
frontal cover
Important setting
HOW TO SWITCH OVER <REMOTE CONTROLLER>
Be sure to set the slide switch inside the remote controller to an appropriate position in accordance with the
installed position of the indoor unit. If the switch is not set correctly, the air conditioner may not function properly.
Where is the indoor unit installed in the room?
Installed at left, (The
distance is not more
than 50cm.)
(Left)
* If the indoor unit is installed more than 50 cm away from the side walls,
cabinets or other nearby objects, set the slide switch to the "center" position.
Temperature button
Horizontal
vane button
OFF-TIMER button
ON-TIMER button
Time setting button
Forward button
Backward button
Clock setting button
Switch
Position of the slide
switch
Display on the
remote controller
Installed at right,(The
distance is not more
than 50cm.)
(Right)
(Center)
How to install battery and set current time
Remove the frontal cover and install batteries.
1
Then, reinstall the cover. Insert the cathode of the
batteries in t�e first. C�eck if t�e polarity is correct.
Press the reset button.
2
Use sharp thing to press it.
·If the reset button is not pressed, the remote controller
can't work normally.
·Note that the pressing shall not be done forcibly.
Press the Clock setting button.
3
Use something sharp at the end to press it.
Press (forward) and
4
setting button), set current time.
·Each press of the Forward button increases one minute;
Each press of the Backward button decreases one minute.
·If you press and hold down the button for a long time, the
set time will increase/decrease in ten minutes intervals.
5 Repress the Clock setting button and close the frontal cover.
Area Left
Is the indoor unit installed
at right, left or center?
4
First, insert the negative electrode
(backward) button (time
Center Right