Mitsubishi Electric MSZ-WG20VA-H1 Operating And Installing Instructions page 40

Split type,wall-mounted inverter heat pump room air conditioner
Table of Contents

Advertisement

Airflow velocity and direction adjustment
Movement of horizontal vane
Cooling/Dry
Horizontal position
·The vane moves to the horizontal position after stopping swing.
Note:
T�e airflow is �ig�er t�an position 1.
1/2 or one
hour later
T�e airflow direction is set to position (2) , (3) or (4), (5)
·When the air conditioner operates for about one hour, the
vane moves to position (1) or (2) automatically. Press the
button Vane on t�e remote controller to c�ange t�e airflow
direction back to original set point.
·The vane moves intermittently
between position (1) and (5). The
vane stays at position (1) and (5) for
a moment.
Note:
Adjust t�e airflow direction by t�e remote controller. Moving t�e vertical vane or
horizontal vane by hand may cause failure.
When the operation mode changes to mode "
to different positions automatically mentioned above.
Press button
to c�ange airflow direction (left/rig�t)
Each press of the button enables the unit to change the vertical vane angle following
the order of:
Blow with swing.
Blow wit� swing enables t�e airflow to reac� eac� corner of t�e room.
Start of heating
Horizontal
position
·After the air conditioner starts to operate, the vane stops in horizontal position.
Once t�e temperature of t�e airflow from indoor unit is enoug� �ig�, t�e vane
will move to Set position 4.
·Once the air conditioner starts to operate, fan speed increases with the
temperature rise of airflow from t�e indoor unit and until t�e set speed.
Start of heating
Horizontal position
Position (1) or (2)
·After the air conditioner starts to operate, the vane stops in horizontal position.
Once t�e temperature of t�e airflow from indoor unit is enoug� �ig�, t�e vane
will move to Set position.
·Once the air conditioner starts to operate, fan speed increases with the
temperature rise of airflow from t�e indoor unit and until t�e set speed.
·The vane moves intermittently between position (2)
and (5). The vane stays at position (2) and (5) for
a moment.
(1)
(5)
(auto)", the horizontal vane changes
(Swing)
11
Heating
When the air is
hot...
Position 4
Horizontal
position
When the air is
hot...
Set position
(2)
(5)

Advertisement

Table of Contents
loading

This manual is also suitable for:

Msz-wg25va-h1

Table of Contents