Download Print this page

AeroGarden 100710-BSS Quick Start Manual page 14

Input voltage: 115v, 60hz, 1.5a

Advertisement

Prepare For Your Next Garden
Cleaning instructions for your aerogarden
Use only water and mild soap when cleaning your AeroGarden (except when Sanitizing - Step 7). Do not use
abrasive cleaners or run through the dishwasher.
When your garden has completed it's growing cycle...
1
Unplug AeroGarden.
Carefully remove Bowl and Grow
2
Surface from Base and bring to
a sink. Set Base and Lamp Hood
aside.
NEVER SUBMERSE BASE AND
CONTROL PANEL IN WATER.
3
Remove Grow Surface from Bowl
and place on a counter near a
sink.
Empty contents of Bowl in sink.
4
Remove Seed Pods and plants
5
from Grow Surface.
• Pull Seed Pods out of Grow
Surface openings.
• Throw away Seed Pods and
plant debris (plant growth and
roots). If you compost, plant
debris can be composted.
6
Rinse and clean Grow Surface,
Pump Stand and Pump Filter.*
• Use a soft scrub brush to clean
tangled roots from underside of
Grow Surface and Pump Stand.
• Remove Pump Filter from
Pump Stand. Gently scrub
roots from Pump Filter.
• Place Pump Filter back into
Pump Stand.
After cleaning, there may still be a few roots
in your Grow Surface, Pump Stand or Pump
Filter. This will not affect the operation of
your AeroGarden.
* iMPortant note: We recommend replacing the Pump Filter after growing
two gardens. order Pump Filters from www.aerogardensupport.com or from
your retailer.
13
7
Sanitize AeroGarden.
Grow
• Fill Bowl ¾ full with water.
Surface
• Add ¼ cup (59ml) of chlorine
• Replace Grow Surface on Bowl,
• Unplug AeroGarden and empty
Plant
Growth
Seed
8
Pod
Rinse AeroGarden.
• Refill Bowl with tap water and
Roots
• Plug in and run AeroGarden
• Unplug AeroGarden, empty Bowl
Pump
Stand
Pump
Filter
9
Towel dry the Bowl and Grow
Surface before putting them back
together and setting them back on
the Base.
10
If your Grow Bulbs have been in use
more than 6 months, they should be
replaced at this time (see page 12).
Your AeroGarden is now ready for
replanting.
bleach.
place Bowl on Base and plug in
AeroGarden for 1-2 minutes.
(Select Salad Greens on Control
Panel to be sure water is flowing.)
bleach water from Bowl.
replace on Base.
for 1-2 minutes. (Select Salad
Greens again.)
and repeat this step (step 8) one
more time.

Advertisement

loading

This manual is also suitable for:

Aerogarden pro100