Related Manuals for AeroGarden AeroGarden 100633
Summary of Contents for AeroGarden AeroGarden 100633
- Page 1 Quick Start Guide Simple Steps To Get Your “Trellis-Ready” Up and Growing * Trellis System not included. See page 13 for details. Model #: 100633-DSS Input Voltage: 120V, 60Hz, 1.5A Date Code:...
-
Page 2: Important Safety Instructions
5. Use AeroGarden only for its intended use as described in instructions. Do not use attachments not recommended by manufacturer. 6. Never operate AeroGarden if it has a damaged cord or plug, if it is not working properly, if it has been dropped and damaged, or if it has been dropped in water. -
Page 3: Quick Start Assembly
Quick Start Assembly Unpack Your AeroGarden Lamp hood (front view) Bowl (front view) Base (front view) Deluxe Grow Bulbs (3) Insert Grow Bulbs into Lamp hood Lamp hood (bottom view) Push straight in. DO NOT TWIST BULBS! remember to replace Grow Bulbs every 6 months. - Page 4 Lamp Arm Center hands over Lamp Arm and push Lamp Hood down until you hear a “click.” Unpack Your AeroGarden Use one hand to grasp Lamp Arm Gently slide AeroGarden toward the surface edge and place other hand under...
- Page 5 Place Your Garden Under: A space that allows 35” (89cm) clearance for the full height of raised lamp On: A sturdy, water- tolerant surface (Metal surfaces may cause noise due to vibration) Near: A standard electrical outlet, per local regulations Away From Reach of children and pets Direct sources of heat (e.g., stove, furnace vents)
-
Page 6: Planting Your Garden
Planting Your Garden Add Water Using a Spouted Container Fill to “Fill To Here” (located inside Bowl) When additional water is needed, “Water Low” light on Control Panel will blink. Add water to raise level up to “Fill To Here” inside Bowl. It is okay to add water up to “Fill To Here”... -
Page 7: Plant Your Garden
• Consider plant height when combining Seed Pods from two 3-pod Seed Kits. Refer to “Plan Your Garden Layout” on page 5 when deciding where to place Seed Pods in your 6-pod AeroGarden. • When planting – use BOTH Starting Nutrients (two tablets) from each 3-pod Seed Kit. - Page 8 Planting Your Garden Place Bio-Domes Place a Bio-Dome on each Seed Pod. Press Bio-Dome down until its rim almost touches Grow Surface. Add Starting Nutrient Tablets and Record Planting Date Record Planting Date Record the date your Seed/Plant Kit was planted on front cover of the Tending &...
- Page 9 Add Nutrients Replace Bulbs Herbs Salad Flowers Greens Vegetables Live Plants note: depending on the plant type selected, your AeroGarden 6 elite + lights will automatically turn on and off at pre-programmed intervals. Plug in view Door Water Low 24-Hour Light...
- Page 10 Add Nutrients once your AeroGarden 6 elite + is set on “24-Hour light” setting, lights will remain on 24 hours a day. To shorten the amount of time lights are on, quickly press and release “lights” button, and lights will turn off. lights will automatically come back on within 12 hours –...
- Page 11 Personalize Your Light Timer Your AeroGarden 6 Elite + has lights and a built-in timer that automatically provide plants with the optimal amount of “sunlight” (about 16 hours) and “night” (about 8 hours), depending on plant type you selected. As long as plants get this amount of light, it does not matter when lights are turned off. * Many people find it conve- nient to have lights go on in the morning and off at night to match their own wake and sleep schedule.
- Page 12 After replacing Grow Bulbs, press “Reset” button to restart grow bulb timer and turn off flashing light. noTe: If you store your AeroGarden 6 elite + be- tween uses, grow bulb timer automatically stops when Garden is unplugged.
- Page 13 As plants grow to 1-2” from lights, raise Lamp Arm one notch at a time (each of the three Lamp Arm sections has three notches). Be sure Lamp Arm is at the lowest setting when you start your AeroGarden 6 Elite + .
- Page 14 Trellis System installation If your AeroGarden 6 Elite + is already assembled, you will need to remove the lamp Hood from lamp Arm, and remove Grow Bulbs from the lamp Hood before starting. It is best to do this when Garden lights are off.
- Page 15 Prepare For Your Next Garden cleaning Instructions for your AeroGarden Use only water and mild soap when cleaning your AeroGarden (except when Sanitizing - Step 6). Do not use abrasive cleaners or run through the dishwasher. When your garden has completed its growing cycle…...
-
Page 16: Add Nutrients
Prepare For Your Next Garden Replanting Your AeroGarden If you have already grown a garden in your AeroGarden 6 Elite + , please follow the instructions below to reset the nutrient timer: • Press and hold “Reset” button until red “Add Nutrients” light blinks 3 or 4 times (about 9 seconds).