A/D Module; Led Module - Fujitsu MB95200H Series Setup Manual

3.4.5 A/D Module

VR1 and VR3 are to demonstrate a MCU A/D converter usage. Select VR1 or VR3 by the
following table.
VR1 is connected to MCU A/D channel 1, and VR3 is connected to MCU A/D channel 0.
Modules
A/D:
VR1
A/D:
VR3

3.4.6 LED Module

There are four LEDs on EV-board to demonstrate the I/O function.
Enable LED2, LED3 and LED4 in the following table,
Modules
LED*:
LED2, LED3, LED4
*LED module has four LEDs in total, but P12 (LED1) is not active in a debug mode using
BGMA.
Starter Kit MB2146-410-01-E Setup Guide V1.1
Chapter 3 EV-board Manual
Header name
SW2: VR1
SW2: VR3
Table 3.4.5-1
Header name
SW2:
LED2, LED3
SW1: LED4
Table 3.4.6-1
MCU-UM-500002-E-11 – Page 13
Settings
Settings