Led Description - Fujitsu MB95200H Series Setup Manual

2.5 LED Description

First, only plug USB cable to PC, check the Power LED on BGMA turns Green. Refer to
Figure 2.5-1.
Second, plug IDC10 cable to the EV-board (target MCU board), then turn on EV-board. After
that check Power LED on the BGMA turns Orange. Refer to Figure 2.5-2.
Starter Kit MB2146-410-01-E Setup Guide V1.1
Chapter 2 BGMA Manual
Green
Figure 2.5-1 BGMA Power LED (1)
5V Power
through
IDC
Cable
Figure 2.5-2 BGMA Power LED (2)
MCU-UM-500002-E-11 – Page 7
USB Plugged to PC
Orange