Hw Module Description And Jumper Settings; Power Module - Fujitsu MB95200H Series Setup Manual

3.4 HW Module Description and Jumper settings

3.4.1 Power Module

Users can select two types of DC power supply to the EV-board. If any of the power supplies
is connected to the EV-board correctly, power LED (LED5) on the EV-board will be on. Refer
to Figure 3.4.1-1.
To select different power supplies, follow the table below,
Power supply
4 AA batteries from
BT1 on the back of
the EV-board.
9V DC from CN6
Starter Kit MB2146-410-01-E Setup Guide V1.1
Chapter 3 EV-board Manual
Figure 3.4.1-1 Power Module
Header name
J1: BAT.
J1: 9V.
Table 3.4.1-1 Power Supply Selection
MCU-UM-500002-E-11 – Page 11
Settings