USB Module Removal
Prerequisite:
Upper Cover Removal
1. Locate USB module (B) on lower cover as shown on
2. Disconnect module FFC (A) from module connector (B). Refer to
3. Disconnect module FFC (A) from mainboard connector (C).
C
C
Figure 3-33. USB Module
NOTE:
NOTE:
The USB module FFC is part of the lower cover FRU (Field Replacement Unit)
component. Do not remove it.
4. Remove screw (D) (M2.5*6.0-I) from lower cover.
5. Remove module from lower cover.
USB Module Installation
1. Install module (B) on lower cover. Refer to
2. Connect module FFC (A) to module connector (B). Refer to
3. Connect module FFC (A) to mainboard connector (C).
4. Install and secure screw (D) (M2.5*6.0-I) to lower cover.
5. Install upper cover.
Machine Maintenance Procedures
C
C
A
A
Figure
Figure
3-31.
Figure
B
B
3-31.
Figure
3-33.
0
3-33.
D
0
3-37