Table of Contents
Advertisement
DAP-1360U Wireless N300 Access Point & Router
User Manual
To use one of existing WAN connections as the default connection, in the Default Gateway
section, select the choice of the radio button which corresponds to this connection.
To go to the simplified mode, click the SIMPLIFIED MODE button (the button is unavailable if
several WAN connections are created).
Figure 53. The Connections Setup / WAN page. The simplified mode.
To edit an existing connection, click the EDIT button. On the opened page, on the Basic tab, the
mandatory settings of this connection will be displayed. To view all available settings of the WAN
connection, go to the All Settings tab. Change the needed parameters and click the APPLY
button.
To disconnect a connection and establish it again, click the RECONNECT button.
To remove an existing connection and create a new one, click the CHANGE CONFIGURATION
button. Upon that the connection creation page opens.
To create several WAN connections, go to the advanced mode. To do this, click the ADVANCED
MODE button.
!
When connections of some types are created, the Connections Setup / WAN page is
automatically displayed in the advanced mode.
Page 61 of 158
Configuring via Web-based Interface
Advertisement
Table of Contents
