Table of Contents
Advertisement
DAP-1360U Wireless N300 Access Point & Router
User Manual
In some cases NTP servers addresses are provided by your ISP. In this case, you need to move the
Get NTP server addresses using DHCP switch in the NTP Settings section to the right and
click the APPLY button. Contact your ISP to clarify if this setting needs to be enabled. If the Get
NTP server addresses using DHCP switch is moved to the right, the NTP Servers section is
not displayed.
To allow connected devices to use the IP address of the access point in the local subnet as a time
server, move the Run as a server for the local network switch to the right and click the
APPLY button.
When the access point is powered off or rebooted, the system time is reset to the default
!
value. If you have set automatic synchronization for the system time, the internal clock of
the device will be configured after connecting to the Inter net. If you have set the system
time manually, you need to set the time and date again (see above).
Page 154 of 158
Configuring via Web-based Interface
Advertisement
Table of Contents
