System Operation; Operation (Local); Default Setting Changes - Toshiba Q7 Installation And Operation Manual

System Operation

Operation (Local)

Read and understand all safety warnings before operating this equipment!
To turn the motor on perform the following steps:
1. Press the SPM key until the Output Frequency screen is displayed (see
2. Press the Speed Ctrl|Local/Remote key to enter the Local mode (green Local LED illuminates).
3. Press the Run Mode|Manual/Auto key (green Manual LED illuminates).
4. Press (and hold) the Up/Down arrow key until the displayed Frequency Command value is at the
desired setting.
5. Press the SPM key to view the running frequency.
6. Ensure that there are no personnel around or near the motor or the motor-driven equipment.
7. Press the Run key and the motor runs at the Frequency Command value.
Note: The speed of the motor may be changed while the motor is running by using the Up/
Down arrow keys to change the Frequency Command value. To change the direction
press and hold the R/W key and momentarily press the Up or Down arrow key
(Up=Forward/Down=Reverse).
8. Press the Stop|Reset key to stop the motor.
Figure 12. Frequency Command screen.

Default Setting Changes

To change a parameter setting, go to the Program menu or the Setup menu by pressing the SPM key
until the desired menu is displayed. From the Program menu press the Up or Down arrow key until the
desired parameter group is displayed. Press the R/W key to access the sub-menu listing. Press the Up or
Down arrow keys to access the parameter to be changed.
From the Setup menu press the R/W key to access the sub-menu items and then use the Up or Down
arrow key to access the parameter to be changed.
Once a parameter setting has been accessed, press the R/W key to enter the Edit mode (screen title
flashes). Use the Up or Down arrow keys to change the parameter setting.
Press the R/W key when done to accept and save the changed setting and remain in the active menu, or
press the SPM key to retain the changed setting in volatile memory (lost when powered down or reset)
and return to the root menu.
Note: Some parameters use the unsaved changed value until the ASD is Reset or powered off
(e.g., Frequency Command, Accel/Decel, etc.).
Repeated R/W key entries loop the menu through its full list of items of the active sub-menu. From any
menu, press the SPM key to return to the root menu. Repeated SPM entries loop the system through the
root menus as shown in
For a complete listing of the Program menu and Setup menu items, see the section titled
Navigation on pg.
32
Figure 11 on pg. 23.
25. The menu items are listed and mapped for convenience.
Figure 12.).
Menu
Q7 ASD Installation and Operation Manual