Q7 Keypad Operation - Toshiba Q7 Installation And Operation Manual

Setup/Program/Monitor Key (SPM) — Provides a means to access the root menus. Pressing the
SPM key repeatedly loops the system through the active root menus (see
Figure 9. The Q7 Keypad.

Q7 Keypad Operation

The Q7 Keypad is the primary input/output device for the user. The Q7 Keypad may be used to
monitor system functions, input data into the system, or perform diagnostics.
Press the SPM key to loop through the root menu selections. Use the R/W key and the Up and Down
arrow keys to access and change the system parameters as described in the section titled
Changes on pg.
From any menu, press the SPM key to return to the root menu.
Panel Control Menu
The (Program
Changes to the listed parameters are effective for commands received via the Q7 Keypad only.
Direction — Forward or Reverse.
Ramped PWM — The PWM frequency ramps from 9.99 kHz to 5 kHz as the ASD output frequency
increases.
PID Control — This feature enables/disables the PID feedback function.
Reset Selection — Enables/Disables the ability to reset the system from the panel.
Accel/Decel Selection — 1 of 4 Accel/Decel profiles may be selected and run.
V/f Group — 1 of 4 V/f profiles may be selected and run.
Stop Pattern — The Decel Stop or Coast Stop settings determines the method used to stop the motor
when using the Stop|Reset key of the keypad.
Note: The Stop Pattern setting has no effect on the Emergency Off settings.
20
RUN Mode
Manual/Auto key
Speed Ctrl
Local/Remote
Key
Up/Down
Arrow Keys
Setup/Program/
Monitor (SPM) Key
32.
) Panel Control menu allows for quick access the ASD parameters listed below.
Figure 11 on pg.
LCD Display
LOCAL, RUN,
and MANUAL
Status LEDs
Run Key
|
Stop Reset Key
|
Read Write Key
Default Setting
Q7 ASD Installation and Operation Manual
23).