Table of Contents
Advertisement
Table insert:
Replace a worn table insert.
The table insert may not project above table surface.
The table insert must be made out of cutable material (e.g.
wood, plastic, aluminium)
The table insert may not project above table surface.
Saw blades:
The servicing of saw blades should only be performed by a
trained person.
Only use sharp and properly set saw blades.
Replacing drive belt:
The belt tension must be inspected regularly.
Disconnect machine from power source.
Open upper and lower doors.
Remove saw blade as described.
Refer to Figure 31:
Remove tension on drive belt (L) by loosening the socket
head screw (13mm wrench required) on the back of the
cabinet that secures the motor.
Using snap ring pliers, remove snap ring (M) that secures
lower wheel (N) to shaft (O).
Slide lower wheel assembly off the shaft (O) which will
dislodge the belt (L). Discard the old belt.
Place new belt onto lower wheel pulley.
Reinstall lower wheel assembly by sliding it back onto the
shaft (O).
Reinstall snap ring (M).
Place new belt (L) partially around motor pulley (P) to get it
started, then turn wheel (N) by hand until belt is completely
seated on motor pulley (P).
Push the motor down to add tension to belt. The belt is
properly tensioned when moderate finger pressure on the
belt between the two pulleys causes a 1/2-inch deflection.
Tighten socket head screw on the back of the cabinet that
secures the motor.
Re-install blade.
Adjusting drive belt tension:
Refer to Figure 31:
Disconnect machine from power source.
Fig.31
With a 13mm wrench, loosen socket head screw on back of
cabinet that secures the motor.
Push motor down to add tension to belt.
The belt is properly tensioned when moderate finger
pressure on the belt between the two pulleys causes a 1/2"
deflection.
Tighten socket head screw that secures motor.
9. Trouble shooting
Motor doesn't start
*No electricity-
check mains and fuse.
*Defective switch, motor or cord-
consult an electrician.
Machine vibrates excessively
*Stand on uneven floor-
adjust stand for even support.
*dust on wheel-
clean tires.
*sawblade has cracks-
replace sawblade immediately
Cut is not square
*Table stop setting wrong.
*Blade guide setting is bad
Cutting surfaces is bad
*Wrong sawblade used
*resin collection on sawblade
*sawblade is dull
*Blade guide setting is bad
*Blade tension too low
*workpiece inhomogeneous
*Feed pressure too high-
Do not force the workpiece.
10. Environmental protection
Protect the environment.
Your appliance contains valuable materials which can be
recovered or recycled. Please leave it at a specialized
institution.
11. Available accessories
Refer to the JET-Price-list
Advertisement
Table of Contents
