Before You Begin - Kohler K-5401TW-2-0 Installation Manual

Veil+ intelligent toilet
Hide thumbs Also See for K-5401TW-2-0:
Table of Contents

Advertisement

BEFORE YOU BEGIN

Please read the following instructions carefully and familiarize yourself with the required tools, materials, and
installation sequences. Follow the section that pertain to your particular installation. This will help you avoid costly
mistakes. In addition to proper installation, please also read all operating and safety instructions.
All information in the instructions is based upon the latest product information available at the time of publication.
Kohler China reserves the right to make changes in product characteristics, packaging, or availability atany time
without notice.
These instructions contain important care, cleaning, and warranty information - please leave instructions for the
consumer.
We appreciate your commitment to Kohler quality. Pleas e take a few minutes to review this manual before
installation. If you encounter any installation or performan ce problems, please don't hesitate to contact us.Thanks
again for choosing Kohler Company.
Pre-arrange enough space for toilet installation. Make su re it will not affect the opening and closing of the door.
面遇到任何問題,務必請您與我們聯繫。
When install the product in the room, a stop valve shall be installed in a close proximity. For emergency
circumstances, the water inlet valve shall be stopped without using any tools; otherwise unexpected failure may
cause the loss to the customer.
Confirm the rough in 305mm, it need reach to 292~350mm, otherwise it may affect installation.
Confirm the distance the water outlet connector away from the finished wall: upper the surface of finished wall by
3mm and lower the surface of finished wall by 5mm otherwise it may affect installation.
DN15mm or larger main water pipe is recommended to ensure following water supply requirements.
Customer shall avoid any obvious pipe shrinkage or blockage from pipe installation or PPR pipe thermal fusion
connection for better flushing effect. Ensure inlet water diameter after connection is greater than 15mm.
Please use the hose and tee valve come with the toilet.
Please use DN32mm or larger relief valve if there's relief valve installed in water supply pipeline.
NOTES
DANGER: Risk of electric shock. Disconnect power before using.
WARNING: Risk of electric shock. Connect only to circuits p r o t e cted by Ground-Fault
Circuit-Interrupters (GFCI's) or Earth-Leakage Circuit-Breakers (ELCB's).
CAUTION: Risk of hazardous gases. If a new toilet is not installed immediately, temporarily place
a rag in the floor flange opening.
NOTICE: Follow all local plumbing and electrical codes.
NOTICE: Receptacles installed in bathrooms to be located at least 1 meter from a bathtub or shower if
practical.
Observe all local plumbing and building codes.
Carefully inspect the new toilet for damage.
Water and electrical supplies may be wall mounted.
There is a wiring schematic on the inside of the of the junction box cover.
WARNING: Risk of electric shock,fire or personal injury. This product must be installed safely.
Connect only to dedicated 110V~, 60Hz, 15A circuit protected by Ground-Fault Circuit-Interrupters
(GFCI's) or Earth-Leakage Circuit-Breakers (ELCB's).
WARNING: Must use 15A receptacle.
1422537-TW01-A
2
VEIL+
INSTALLATION INSTRUCTIONS
INTELLIGENT TOILET
K-5401TW-2-0
Kohler Co.

Advertisement

Table of Contents
loading

Table of Contents