Siemens POS8.4420/109 Basic Documentation page 53

A6V11471220_en--_e
(DPT_ID =
21.002)]
PID_ORDER 15 1 PDT_GENERIC
_INFO _10
DPT_OrderInfo
(DPT-ID =
60110.60002)
PID_ROUTIN 51 1 U8 /
G_COUNT PDT_UNSIGNE
D_CHAR
PID_PROG_ 54 1 B8 /
MODE PDT_BITSET8
PID_PRODU 55 1 PDT_GENERIC
CT_ID _10
DPT_Product_I
dentification
(DPT-ID =
60110.60002)
PID_MAX_A 56 1 U16 /
PDU_LENGT PDT_UNSIGNE
H D_INT
PID_SUBNE 57 1 U8 /
T_ADDR PDT_UNSIGNE
D_CHAR
PID_DEVICE 58 1 U8 /
_ADDR PDT_UNSIGNE
D_CHAR
PID_IO_LIST 71 25 U16 /
PDT_UNSIGNE
D_INT[ ]
24 U16U32U8N8 /
DevIdent 1
1 PDT_GENERIC
_08
DevIdentAut 24 B1 /
1
PDT_BINARY_I
oSend 2
NFORMATION
B1 /
DPT_Enable
DevIdentHop 24 1 N8 /
CountType 3 PDT_ENUM8
DPT_HopCount
the Verify-Mode Flag.
When using
connectionless
UserMemWrite, then
verifyMode shall be
active
R ---- manufacturer specific
Order Information
RW ---- This Property shall
include the default
value for the hop
count. (This is a
parameter for the
Network Layer of the
device.). It shall be
used to adjust the
default value of the
hop count parameter
of the Network Layer
RW ---- Bit 0 = Programming
Mode
all other bits reserved
for future use
R ---- manufacturer specific
device type
For this property,
Synco rules apply:
Serial Number, Device
Family, Device Variant
(concatenated)
R ---- maximal supported
APDU-length for
management of the
device
R ---- Subnetwork Address
part (high octet) of the
Individual Address
R ---- Device Address part
(low octet) of the
Individual Address
R ---- Array which lists for
each object index the
Object Type
IR.re Used for SARB
R
q localization,
communication test.
Sent with an LTE-
InfoReport after power
up and periodically if
DevIdentAutoSend is
enabled
Enables
RW ----
PID_DEVICE_IDENT
to be sent
spontaneously at
power up and in
regular intervals
RW ---- Defines the used hop
count for DevIdent:
0: PSD defined
1: 0
10
Appendix
Object list
OL
chapter 3-5-2, clause
3.19
DM_UserMem_Write
DPT-ID out of
proprietary range, as
Specified in Synco
KNX Standard,
chapter 3-5-1, clause
4.3.2
PID_ROUTING_COU
NT
DPT-ID out of
proprietary range, as
Specified in Synco
Default = 60 bytes
acc. KNX Standard,
chapter 3/5/1
Resources,
PID_IOLIST
DPT definition: SD-
T060.0601_EN_SARB
_Data_Aquisition
7.1.2.9.3
DPT definition: SD-
T060.0601_EN_SARB
_Data_Aquisition
53 | 70