Electrolux LBU15 Instruction Manual page 7

Electrical Installation
WARNING
B e fo re c o n n e c t i n g yo u r
product, check the voltage
in the socket where the
product will be plugged
in is similar to the voltage
i n d i c a t e d o n t h e l a b e l
located on the plug (of the power cord).
There is a protection mechanism to prevent
damage to the electrical system of your washing
machine.
If your washing machine is connected at a voltage,
an automatic voltage recognition system will not
allow the product to work. However, it will not cause
any damage to the electrical system of the washing
machine. Disconnect the plug from electrical
socket and make sure the voltage is correct.
WARNING
Connect your product to
a n e xc l u s i ve s o c k e t . D o
not use ex tension cords
or T type adaptors. Do not
use adaptors.
If the electrical socket in your residence does not
align with the rules, we recommend changing it with
an electrician you trust.
Remember that to enjoy the advance and the safety,
it is necessary to have a grounded electrical socket.
If in doubt, consult a professional.
Ground Wire
Your product is equipped with a 3-pin plug. Plug
it into a properly grounded electrical socket. The
ground wire pin of the plug cannot be cut.
Blackout
Occasionally, there may be blackouts due to thun-
derstorms or other causes. Unplug the power cord
from the electrical socket when there is a blackout.
Once power is restored, plug the power cord into
the electrical socket. If the blackout is extended for
a long period, clean the washer before reusing it.
Circuit Breaker
It is mandatory to install an exclusive circuit breaker for
the washing machine.
If in doubt regarding the electrical system of your
residence, consult the energy provider .
Voltage 220 V - Bipolar
Tripolar socket
Tripolar
plug
Ground wire
For a 220 V product (between two lines), use a 15 A
bipolar circuit breaker and a 20 A tripolar socket.
Voltage 220 V - Monopolar
Neutral
Tripolar
socket
Tripolar
plug
Ground wire
Some regions have 220 V between the line and neutral.
In this case, use a 15 A circuit breaker in the line.
15 A
bipolar
circuit
breaker
Line cable
15 A circuit
breaker
Line cable
7