Sony Handycam DCR-SR35E Handbook page 79

media (p. 60, 89). Delete unnecessary
images (p. 37).
While [DROP SENSOR] (p. 67) is

activated, you cannot record images.
The temperature of your camcorder is

extremely high. Turn off your camcorder
and leave it for a while in a cool place.
You cannot record images in sleep mode.

Cancel QUICK ON (p. 27).
Your camcorder is recording the image you

have just shot onto the media. You cannot
make a new recording during this period.
The temperature of your camcorder is

extremely low. Turn off the camcorder
and take it to a warm place. Leave the
camcorder there for a while, then turn on
the camcorder.
The ACCESS lamp remains lit even
when you stop recording.
Your camcorder is recording the image you

have just shot on the media.
The recording angle looks different.
Recording angle may vary depending on

the condition of the camcorder. This is not
a malfunction.
The actual recording time for movie is
less than the expected approximate
recording time of the media.
Depending on the recording conditions,

the time available for recording may be
shorter, for example when recording a fast
moving object, etc. (p. 57).
The recording stops.
The temperature of your camcorder is

extremely high. Turn off your camcorder
and leave it for a while in a cool place.
The temperature of your camcorder is

extremely low. Turn off the camcorder
and take it to a warm place. Leave the
camcorder there for a while, then turn on
the camcorder.
If vibrations occur continuously, recording

may stop.
There is a time difference between the
point where you press START/STOP
and the point that movie recording
starts/stops.
On your camcorder, there may be a slight

time difference between the point where
you press START/STOP and the actual
point that movie recording starts/stops.
This is not a malfunction.
The auto focus does not function.
Set [FOCUS] to [AUTO] (p. 71).

The recording conditions are not suitable

for auto focus. Adjust the focus manually
(p. 71).
[STEADYSHOT] does not function.
Set [STEADYSHOT] to [ON] (p. 58).

[STEADYSHOT] may not be able to

compensate for excessive vibrations.
Tiny spots in white, red, blue, or green
appear on the screen.
The spots appear when you are recording

with [S. NIGHTSHOT PLS] or [COLOR
SLOW SHTR]. This is not a malfunction.
The color of the image is not correctly
displayed.
Set the NIGHTSHOT PLUS switch to OFF

(p. 28).
The screen image is bright, and the
subject does not appear on the screen.
Set the NIGHTSHOT PLUS switch to OFF

(p. 28).
The screen image is dark, and the
subject does not appear on the screen.
Press and hold DISP/BATT INFO for a few

seconds to turn on the backlight (p. 19).
79