Sony Handycam DCR-SR35E Handbook page 14

For DCR-SR35E/SR36E/SR45E/
SR46E:
Connect the power cord (mains
lead) to the AC Adaptor and the wall
outlet (wall socket).
The CHG (charge) lamp lights up and
charging starts.
The CHG (charge) lamp turns off when
the battery is fully charged. Disconnect
the AC Adaptor from the DC IN jack.
Disconnect the AC Adaptor from the
DC IN jack holding both the DC plug
and the Handycam Station (DCR-
SR55E/SR65E/SR75E/SR85E) or your
camcorder (DCR-SR35E/SR36E/SR45E/
SR46E).
 Tips
For DCR-SR55E/SR65E/SR75E/SR85E:

Same as DCR-SR35E/SR36E/SR45E/

SR46E, you can charge the battery pack
by connecting the AC Adaptor to your
camcorder.
For DCR-SR55E/SR65E/SR75E/SR85E:
To remove your camcorder from the
Handycam Station
Turn off the power, then remove the
camcorder from the Handycam Station
holding both your camcorder and the
Handycam Station.
1
To remove the battery pack
Turn the POWER switch to OFF (CHG).
Slide the BATT (battery) release lever and
remove the battery pack.
BATT (battery)
release lever

Notes
When you remove the battery pack or

disconnect the AC Adaptor, make sure that the
(Movie) lamp/
ACCESS lamp (p. 25) is turned off.
When you store the battery pack, fully discharge

the battery before storing it for an extended
period (see page 92 for the details of storage).
To use a wall outlet (wall socket) for the
power source
Make the same connections as you do when
charging the battery pack. The battery pack
will not lose its charge in this case.
To check the remaining battery (Battery
Info)
Set the POWER switch to OFF (CHG),
then press DISP/BATT INFO.
(Still) lamp (p. 17)/