Sony NEX-FS100E Operating Manual page 75

MONO
Outputs in monaural.
XLR SET
XLR AGC LINK
x
You can select either linked or separate
AGC (Auto Gain Control) of CH1 and CH2
when using an external microphone.
B SEPARATE
Separately applies the AGC for CH1/CH2.
Sound inputs from CH1/CH2 will be
recorded as separate sound.
LINKED ( )
Applies the AGC of CH1 linked with that
of CH2. Sound inputs from CH1/CH2 will
be recorded as a set of sound such as stereo
sound. A appears on the status check
screen.
b Notes
• This function is available when the CH1 and
CH2 switches are set to AUTO and the INPUT
1 and INPUT 2 switches are both set to MIC or
both set to LINE (p. 35).
INPUT1 TRIM
x
You can adjust the input signal level from
INPUT 1.
-18dB, -12dB, -6dB, B0dB, +6dB,
+12dB
b Notes
• The setting is not effective when you set the
INPUT 1 switch to LINE.
x INPUT1 WIND
B OFF
Disables wind noise reduction.
ON
Enables wind noise reduction.
appears on the status check screen.
b Notes
• The setting is not effective when you set the
INPUT 1 switch to LINE.
INPUT2 TRIM
x
x INPUT2 WIND
You can set INPUT 2 in the same way as
INPUT 1.
z Tips
• -48 dBu is set as 0 dB in your camcorder.
• Set INPUT TRIM to [0dB] for the supplied
microphone.
• The INPUT TRIM function adjusts the input
level from an external microphone. When using
a highly sensitive microphone or recording loud
sound, set this to the minus side. When using a
less sensitive microphone or recording quiet
sound, set it to the plus side.
• When recording loud sound, the sound may be
distorted at either the input point or the
recording point. If it is distorted at the input
point, adjust the sound using the INPUT TRIM
function. If it is distorted at the recording point,
lower the total volume level manually.
• If you set INPUT TRIM too far to the minus
side, the microphone volume becomes too low,
resulting in a poor signal to noise ratio.
• Test the effect of [XLR SET] according to the
microphone used or the sound field of the
recording site before actual recording.
75