Recording Sound Via The Supplied Microphone; Recording Sound From An External Audio Device - Sony NEX-FS100E Operating Manual

Audio setup (Continued)
Recording sound via the
supplied microphone
The sound will be recorded in monaural.
1
Attach the supplied microphone
(p. 11) and connect it to the INPUT
1 jack F.
2
Set the CH1 (INPUT 1/INPUT 2) B
and CH2 (INPUT 1/INPUT 2) H
switches to INPUT 1.
The same sound will be recorded on
both CH1 and CH2.
3
Set the INPUT 1 switch A to
MIC+48V.
36
Recording sound from an
external audio device
To use an external audio device, or a
microphone other than the supplied
microphone, change the following settings.
1
Select the input source.
Set the INPUT 1/INPUT 2 switches
according to the devices connected to
the INPUT 1/INPUT 2 jacks.
Audio devices
External audio device
(mixer, etc.)
Dynamic microphones or
microphones with a built-
in battery
+48V powering
(
Phantom powering)
microphone
b Notes
• If you connect a device that does not
support +48V phantom power, malfunction
may result from setting this switch to
MIC+48V. Check before connecting the
device.
• When there is no audio device connected to
an INPUT jack, set the INPUT switch of
that jack to LINE to prevent noise.
2
Set the input level of the
microphone.
• Set the input level to the sensitivity of
an XLR microphone you are using
with [INPUT1 TRIM]/[INPUT2
TRIM] in the menu (p. 75). [0dB] will
be appropriate for the supplied
microphone (ECM-XM1).
• You can set an input level between
-60 dBu (+12 dB) and -30 dBu
(-18 dB) by 6 dB. The default setting
is -48 dBu (0 dB).
Switch
position
LINE
MIC
MIC+48V