2
3. Fill:
• Clutch master cylinder reservoir
(with the specified amount of the recom-
mended clutch fluid)
Recommended fluid
DOT 4
EWA13370
WARNING
• Use only the designated clutch fluid. Other
clutch fluids may cause the rubber seals to
deteriorate, causing leakage and poor
clutch performance.
• Refill with the same type of clutch fluid that
is already in the system. Mixing clutch flu-
ids may result in a harmful chemical reac-
tion, leading to poor clutch performance.
• When refilling, be careful that water does
not enter the clutch fluid reservoir. Water
will significantly lower the boiling point of
the clutch fluid and could cause vapor lock.
ECA13420
NOTICE
Clutch fluid may damage painted surfaces or
plastic parts. Therefore, always clean up any
spilt clutch fluid immediately.
TIP
In order to ensure a correct reading of the clutch
fluid level, make sure the top of the reservoir is
horizontal.
4. Bleed:
• Clutch system
Refer to "BLEEDING THE HYDRAULIC
CLUTCH SYSTEM" on page 3-14.
5. Check:
• Clutch fluid level
Below the minimum level mark "a" → Add the
recommended clutch fluid to the proper level.
Refer to "CHECKING THE CLUTCH FLUID
LEVEL" on page 3-13.
1
New
3
a
b
6. Check:
• Clutch lever operation
Soft or spongy feeling → Bleed the clutch
system.
Refer to "BLEEDING THE HYDRAULIC
CLUTCH SYSTEM" on page 3-14.
EAS2S31037
REMOVING THE CLUTCH RELEASE
CYLINDER
1. Remove:
• Clutch hose union bolt "1"
• Clutch hose gasket "2"
• Clutch hose "3"
TIP
Put the end of the clutch hose into a container
and pump out the clutch fluid carefully.
2
EAS25330
CHECKING THE CLUTCH RELEASE
CYLINDER
Recommended clutch component replace-
Piston seals
Clutch hose
Clutch fluid
5-62
CLUTCH
a
3
1
ment schedule
Every two years
Every four years
Every two years and
whenever the clutch
is disassembled