Adjusting The Exup Cables - Yamaha VMAX 2009 Service Manual

17
16 5
4
9
15
20
18
8
1
12
5. Install:
• Fuel tank
Refer to "FUEL TANK" on page 7-1.
• Rear fender
• Passenger seat
Refer to "GENERAL CHASSIS" on page 4-1.
EAS21100

ADJUSTING THE EXUP CABLES

1. Remove:
• EXUP valve pulley cover "1"
17
20
3
9
15
14
14
8
6
6
2
7
13
12
10
11
18
19
2. Check:
18
• EXUP system operation
M MMM M MMM M
a. Activate the diagnostic mode and select the
12
diagnostic code No. D: 53.
Refer to "FUEL INJECTION SYSTEM" on
page 8-33.
b. Set the engine stop switch to "
c. Turn the main switch to "ON".
d. Check that the EXUP valve operates proper-
ly.
TIP
Check that the projection "a" on the EXUP valve
pulley contacts the stopper "b" (fully open posi-
tion). If the projection does not contact the stop-
per, adjust the EXUP cable.
(4)
21
L LLL L LLL L
3. Adjust:
• EXUP cable
M MMM M MMM M
a. Loosen the locknuts "1" and "2".
b. Turn the adjusting bolt "3" in or out until EXUP
cable 1 is taut and the projection "a" on the
EXUP valve pulley is lightly contacting the
stopper "b" on the EXUP cable bracket.
c. Turn the adjusting bolt "4" in or out until the
tension in EXUP cable 2 is the same as the
tension in EXUP cable 1.
d. Tighten the locknuts "1" and "2" to specifica-
tion.
3-18
M MMM M M MMM M M MMM M
b
a
L LLL L L LLL L L LLL L
M MMM M M MMM M M MMM M
ENGINE
1
M MMM M MMM
".
L LLL L LLL
M MMM M MMM