Yamaha VMAX 2009 Service Manual page 41

• If, when the engine is running while the system
status menu is displayed, the fuel level warning
light or coolant temperature warning light
comes on, the Normal mode is automatically
displayed.
1. Push "SELECT" to highlight "System status",
then push "RESET".
2. Push "SELECT" to highlight "Yes", then push
"RESET". (Highlighting "No" and pushing
"RESET" returns to the previous menu.)
The display changes to the status screen.
Push "SELECT" and the various tripmeters and
the odometer are displayed in the following or-
der:
(TRIP-F) → TRIP-1 → TRIP-2 → ODO
→ (TRIP-F)
Push "RESET" to reset a tripmeter.
TIP
• Push "SELECT" for at least two seconds to
switch between miles and kilometers.
• Pushing "RESET" displays the Normal mode
for five seconds. Pushing "SELECT" and "RE-
SET" for at least three seconds, changes the
display to the Normal mode.
• To perform further multi-function display set-
tings, enter the Select mode again by pushing
and holding "SELECT" and "RESET" for at
least three seconds.
Resetting the maintenance counters
This function allows you to reset the mainte-
nance counters for the tires, the engine oil, and
an item of your choice.
1. Push "SELECT" to highlight "Maintenance",
then push "RESET".
2. Push "SELECT" to highlight the item to reset.
3. Push "RESET" to reset the item.
TIP
The bottom area was left blank for another item
the rider cares to check the distance of since it
has been changed, replaced or checked (i.e., air
filter element, engine parts, etc.).
1-32
FEATURES