Epson WF-110 Series Manual page 121

User's Guide
Code Situation
W-11 An ink pad is nearing the end of its
service life.
W-12 Ink cartridge is not installed
correctly.
W-13 Installed ink cartridge is cannot be
used with this printer.
I-22
Set the Wi-Fi from the Push Button
(WPS).
I-23 Set the Wi-Fi from the PIN Code
(WPS).
I-31
Set the Wi-Fi from the Wi-Fi Auto
Connect.
I-41 Paper Configuration is disabled.
Some functions cannot be used.
I-81 The printer is switching to built-in
battery mode because the AC
adapter is not connected, the
external battery has been removed,
there is not enough power in the
battery, or a battery error has
occurred.
- Ink is low.
- Ink is expended and you need to
replace the ink cartridges.
- A non-genuine battery is installed.
Recovery The printer has started in recovery
Mode mode because the firmware update
failed.
* In some print cycles a very small amount of surplus ink may be collected in the ink pad. To prevent ink leakage
from the pad, the printer is designed to stop printing when the pad has reached its limit. Whether and how often
this is required will vary according to the number of pages you print, the type of material that you print and the
number of cleaning cycles that the printer performs. The need for replacement of the pad does not mean that your
Solving Problems
Solutions
Contact Epson or an authorised Epson service provider to replace the
ink pad*. It is not a user-serviceable part. The message will be
displayed until the ink pad is replaced.
Press the OK button to resume printing.
Press down each of the ink cartridges gently. Make sure they click into
place.
Replace the ink cartridges with the ones compatible with this printer.
Push the access point button. If there is no button on the access
point, open the access point setting window, and then click the
button displayed in the software.
Enter the PIN code displayed on the LCD screen into the access point
or computer within two minutes.
Install the software on your computer, and then press the OK button
when Wi-Fi setup starts.
If the Paper Configuration is disabled, you cannot use AirPrint. In
addition, a message notifying you of paper size and type mismatch is
not displayed. Keep the setting enabled unless you always use the
same size and type of paper, and do not need to change the paper
settings.
The print speed may be slower when the printer is in built-in battery
mode. Connect the AC adapter to the printer or install the external
battery when you do not want to change the print speed.
You can continue printing until you are prompted to replace the ink
cartridge(s). However, note that the printer cannot print if any one of
the ink cartridges is expended. Prepare new cartridge(s) as soon as
possible.
To ensure you receive premium print quality and to help protect your
print head, a variable ink safety reserve remains in the cartridge when
your printer indicates it is time to replace the cartridge. Replace the
cartridge when you are prompted to do so.
Remove the external battery.
Follow the steps below to try to update the firmware again.
1. Connect the printer with the AC adapter.
2. Connect the computer and the printer with a USB cable. (During
recovery mode, you cannot update the firmware over a network
connection.)
3. Visit your local Epson website for further instructions.
121