Step 5: Connecting The Power Cord; Step 6: Preparing The Remote - Sony RDR-HX900 Operating Instructions Manual

Step 5: Connecting the
Power Cord
Step 6: Preparing the
Remote
Connect the supplied power cord to the A( IN
terminal of the recorder. Then plug the recorder
and TV power cords into an AC outlet. After you
connect the power cord, you must wait for a
short while before operating the recorder. You
can operate the recorder only after the front panel
display lights up and the recorder enters standby
mode.
If you connect additional equipment to this
recorder (page 29), be sure to connect the power
cord only after all connections are complete.
You can control the recorder using the supplied
remote. Insert two size AA (R6) batteries by
matching the (_ and Q ends on the batteries to the
markings inside the battery compartment. When
using the remote, point it at the remote sensor []
on the recorder.
212
o
g
®
I _L?JI_!
to AC outlet
• If the supplied remote imerferes your other Sony DVD
recorder or player, change the command mode number
tbr this recorder (page 23).
• Use the battmies correctly to avoid possible leakage
and corrosion Do not touch the liquid with bare hands
should leakage occm Obsms,e tl:e tbllowing:
Do not use a new batte: T with an old baltew, or
batteries of difTerent manufactmers.
Do not attempt to recharge the batteries.
If you do not intend to use the remote for an extended
period of time, remove the batteries.
If batte: T leakage occurs, wipe out any liqmd inside
the battery compa:tme::t, and inse:t new battaies.
• Do not expose the remote sensor (marked [] on the
fiont panel) to st:ong light, such as direct stmlight or
lighting apparatus. The recordm may not respond to the
remote.
•._continued
21