Table of Contents
Advertisement
Removing the CD player section /
cassette player section (See Fig.6 ~ 10)
Prior to performing the following procedure, remove
the front panel assembly.
1.
Remove the ten screws D, the screw E
attaching the rear panel on the back of the body.
2.
Remove the three screws G and the two screws H
attaching the heat sink on the left side.
3.
Remove the three screws I attaching the CD player
section and the cassette player section on the both
sides of the body.
4.
Disconnect the card wire from connector CN702 on
the main board in the CD player section on the back
of the body.
5.
Remove the CD player section upward.
CAUTION:
When reassembling, joint the CD player
section and the cassette player section
at four joints b.
CD player section
Joint b
Cassette player section
Fig.9
and F
CN702
CD player section
E
D
Rear panel
Fig.6
H
G
Heat sink
Fig.7
I
Fig.8
Cassette player section
Fig.10
KW-XC828
D
F
D
G
I
I
Joint b
Joint b
1-5
Advertisement
Table of Contents
