JVC KW-XC8 Service Manual page 16

KW-XC828
Removing the trigger arm
Prior to performing the following procedure, remove
the top cover, the connector board and the clamper
unit.
1. Turn the trigger arm in the direction of the arrow to
release the joint k and pull out upward.
CAUTION: When reassembling, insert the part l and
m of the trigger arm into the part n and
o at the slot of the chassis rivet
assembly respectively and join the joint
k at a time.
Removing the top plate assembly
Prior to performing the following procedure, remove
the top cover, the connector board, the chassis unit,
and the clamper assembly.
1. Remove the screw H.
2. Move the top plate assembly in the direction of the
arrow to release the two joints p.
3. Unsolder the wire marked q if necessary.
1-12
(See Fig.18 and 19)
Chassis rivet assembly
(See Fig.20)
Chassis rivet assembly
Fig.18
Trigger arm
Part l
Part m
Fig.19
Top plate assembly
H
Fig.20
Joint k
Trigger arm
Part n
Part o
Joints p
q