Sony DAR-X1R Operating Instructions Manual page 129

TV programme reception does not fill the
screen.
, Set the channel manually in "Channel Setting" in
the "Basic" setup (page 112).
, Select the correct source using the INPUT
SELECT button, or select a channel of any TV
programme using the PROG +/– buttons.
TV programme pictures are distorted.
, Reorient the TV aerial.
, Adjust the picture (see the TV's instruction
manual).
, Place the recorder and TV farther apart.
, Place the TV and any bunched aerial cables
farther apart.
, The aerial cable is connected to the AERIAL
OUT jack on the recorder. Connect the cable to
the AERIAL IN jack.
TV channels cannot be changed.
, The channel is disabled (page 112).
, A timer recording started, which changed the
channels.
The picture from equipment connected to the
recorder's input jack does not appear on the
screen.
, If the equipment is connected to the LINE 1 – TV
jack, select "L1" in the front panel display by
pressing PROG +/– or INPUT SELECT.
If the equipment is connected to the LINE 2 IN
jacks, select "L2" in the front panel display by
pressing PROG +/– or INPUT SELECT.
If the equipment is connected to the LINE 3/
DECODER jack, select "L3" in the front panel
display by pressing PROG +/– or INPUT
SELECT.
If the equipment is connected to the DV IN jack,
(this is usually for a digital video camera
connection), select "DV" in the front panel
display by pressing INPUT SELECT.
The playback picture or TV programme from
the equipment connected through the recorder
is distorted.
, If the playback picture output from a DVD
player, VCR, or tuner goes through your recorder
before reaching your TV, the copy-protection
signal applied to some programmes could affect
picture quality. Disconnect the playback
equipment in question and connect it directly to
your TV.
The picture does not fill the screen.
, Set "TV Type" of the "Video Output" in the
"Video" setup in accordance with the screen size
of your TV (page 117).
The picture does not fill the screen, even
though the picture size is set in "TV Type" of
the "Video Output" in the "Video" setup.
, The picture size of the title is fixed.
The picture is black and white.
, Check that "Line1 Output" of the "Scart Setting"
in the "Video" setup is set to the appropriate item
that conforms to your system (page 118).
, If you are using a SCART cord, be sure to use
one that is fully wired (21 pins).
Colour irregularity occurs on the TV screen.
, The subwoofer and the front speakers in this
system are magnetically shielded to prevent
magnetic leakage. However, some leakage may
occur, as a high-strength magnet is employed. If
this happens, check the following items:
• If the speakers are used with a CRT-based TV
or projector, install the speakers at least 0.3 m
from the TV set.
• If the colour irregularity persists, turn off the
TV set once, then turn it on after 15 to 30
minutes.
• If howling occurs, reposition the speakers
farther away from the TV set.
• Make sure that no magnetic object (magnetic
latch on a TV stand, health care device, toy,
etc.) is placed near the speakers.
GB
,continued 129