Installing The Speakers On A Wall - Sony DAR-RH1000 Operating Instructions Manual

Centre speaker
4.6 mm
10 mm
Foot pad
Surround speaker
Foot pad
Notes
• If you do not set the speaker correctly, the speaker may
fall down and cause injury.
• Use screws that are suitable for the wall material and
strength. In the case of a plaster board wall, attach the
screws securely to a beam and fasten them to the wall.
• Install the speakers on a vertical and flat wall where
reinforcement is applied.
• Contact a screw shop or installer regarding the wall
material or screws to be used.
• Sony is not responsible for accident or damage caused
by improper installation, insufficient wall strength,
improper screw installation, or natural calamity, etc.
20
4.6 mm
10 mm

Installing the speakers on a wall

(DAR-RH1000)
1
Prepare screws (not supplied) that are suitable
for the hole on the back of each speaker.
Minimum 25 mm
Speaker rear hole
2
Fasten the screws to the wall.
The screws should protrude 8 to 9 mm.
8 to 9 mm
3
Attach the supplied wall-mount pads on the
rear of the speaker.
4 mm
4.6 mm
10 mm
Wall-mount pads
(7 × 7 mm, 3 mm thick)