Table of Contents
Advertisement
Ex.: Folder name (when a USB device is played)
Ex.: When a USB device is stopped
Total group number
Changing the brightness of the
display
Remote control
Each time you press the button, the brightness of the
display changes.
When the power is supplied through the AC cord:
When the power is supplied through the
batteries:
The setting is stored even if the power is turned off.
0
Total track number
Main unit
–
Activating/deactivating the Auto
Power Save (A.P.S.)
Remote control
Press the button once to display the current setting.
Press it again to change the setting.
If no operation is performed for 15 minutes in the
following situations, the System turns off
automatically.
- The volume level is set to Min or muting is activated.
- "iPod", "USB" or "SD" is selected as the source, and
no device is connected.
- "BLUETOOTH" or "NETWORK" is selected as the
source, and no wireless connecion with the System.
- "USB" or "SD" is selected as the source, and
playback is stopped.
- "AUDIO IN" is selected as the source, and no sound
is received.
During the 15-minute countdown, "A.P.S." is shown
0
on the display every minute.
Approximately 30 seconds before the power is
0
turned off, "A.P.S." starts to blink.
The 15-minute countdown restarts when you
0
perform button operations or connect/disconnect a
device.
This function has priority over the daily timer and
0
sleep timer.
This function is on at the initial setting.
0
Main unit
–
(Canceled)
15
Advertisement
Table of Contents
