Panasonic PT-RZ31К Operating Instructions Manual page 147

4) Press as to select [ACTIVE FOCUS OPTIMIZER].
5) Press the <ENTER> button.
f The [ACTIVE FOCUS OPTIMIZER] screen is displayed.
6) Press as to select [FOCUS OFFSET SETUP].
7) Press the <ENTER> button.
f The [FOCUS OFFSET SETUP] screen is displayed.
8) Press as to select [SETUP ASSISTANT].
9) Press the <ENTER> button.
f If the [PROJECTOR SETUP] menu → [LIGHT OUTPUT] is set to [100.0%], the internal focus test pattern of
signal level approximately 50 % is projected, and the [SETUP ASSISTANT] screen (page 1/8) is displayed.
Proceed to Step 11).
f If the [PROJECTOR SETUP] menu → [LIGHT OUTPUT] is set to less than [100.0%], the confirmation
screen is displayed. Proceed to Step 10).
10) Press qw to select [NEXT], and press the <ENTER> button.
f Even if the [PROJECTOR SETUP] menu → [LIGHT OUTPUT] is set to less than [100.0%], the projector will
operate with the [100.0%] setting while [SETUP ASSISTANT] is executing. Once [SETUP ASSISTANT] is
completed, it will return to the original [LIGHT OUTPUT] setting value.
f After confirming the confirmation message, press qw to select [NEXT], and press the <ENTER>
button. The internal focus test pattern of signal level approximately 50 % is projected, and the [SETUP
ASSISTANT] screen (page 1/8) is displayed.
f To cancel the setting by [SETUP ASSISTANT], press qw to select [CANCEL], and press the <ENTER>
button. [SETUP ASSISTANT] is cancelled, and the [FOCUS OFFSET SETUP] screen is displayed.
11) Wait until [Waiting time] turns [0s].
f Wait until the focus is stabilized.
f When the [Waiting time] turns [0s], the [Please wait...] message disappears, and [NEXT] becomes
selectable.
12) Press qw to select [NEXT], and press the <ENTER> button.
f The [SETUP ASSISTANT] screen (page 2/8) is displayed.
f It will return to previous screen by selecting [BACK] and pressing the <ENTER> button.
13) Press asqw to select [FOCUS POSITION].
14) Press qw to adjust the focus.
15) Press asqw to select [NEXT], and press the <ENTER> button.
f The [SETUP ASSISTANT] screen (page 3/8) is displayed.
16) Press asqw to select [TEST PATTERN].
17) Press qw to select [EXTERNAL].
f The items will switch each time you press the button.
[INTERNAL]
[EXTERNAL]
18) Press asqw to select [NEXT], and press the <ENTER> button.
f The [SETUP ASSISTANT] screen (page 4/8) is displayed.
f It will return to previous screen by selecting [BACK] and pressing the <ENTER> button.
19) Wait until [Waiting time] turns [0s].
f Wait until the focus is stabilized.
f When the [Waiting time] turns [0s], the [Please wait...] message disappears, and [NEXT] becomes
selectable.
Chapter 4 Settings — [PROJECTOR SETUP] menu
Select this item when using the internal test pattern for focus adjustment.
Uses the input image from the external device for focus adjustment. If the level of [Brightness of the
image] falls below the specified value, [NEXT] cannot be selected. When the bright image with a
brightness level indicated in the menu screen (OSD) or greater is input, [NEXT] can be selected.
ENGLISH - 147