Connecting Your Network Camera - Panasonic KX-HGW600 Operating Instructions Manual

Operating Instructions
2.2.3

Connecting your Network Camera

Setting up your Network Camera automatically
Once you connect your Panasonic Network Cameras (KX-HCM series) to the
KX-HGW600 and turn them on, the network settings such as IP address, port no. are
configured automatically by the Automatic Setup function. After completing the Internet
configuration, make sure the target Network Camera is turned off and follow the steps
below.
1.
a) To connect the KX-HGW600 and Network Camera with an Ethernet cable,
b) To connect the KX-HGW600 and Network Camera in the wireless network,
Note
All Ethernet jacks have an automatic MDI/MDIX feature, which means either a
"straight" or "cross" cable can be used to connect to any jack. The KX-HGW600
will automatically detect which cable has been inserted.
34
connect the Ethernet cable to one of the LAN 1—4 jacks of the KX-HGW600
and the other end to the Ethernet jack of the Network Camera.
To modem
locate the wireless Network Camera near the KX-HGW600.
LAN1—4 jacks
To PC
Ethernet cable
Ethernet jack