6.1.9
Resetting the Camera to Factory Default
All camera settings are reset to factory default when the Execute button is clicked.
To restore the wireless connection, access the camera by using a wired connection
and set up the wireless configuration. (For BL-C20A, see Getting Started.)
1.
Click [Reset to Factory Default] on the Maintenance page.
2.
Click [Execute].
•
The indicator blinks orange, and then turns off for 5 seconds.
•
All camera settings (user name, password, IP address, subnet mask etc.)
are reset to factory default.
•
If the camera is reset to factory default, the network connection mode
changes to [Automatic Setup]. Reconfigure the camera referring to
Getting Started.
Note
•
The internal clock will not be reset, but the time format will return to AM/
PM mode (see page 48).
•
See page 109—page 117 for the default settings.
•
Pressing the FACTORY DEFAULT RESET button resets the camera to
factory default (see page 108).
•
All buffered images on the internal memory are deleted when resetting the
camera to factory default.
•
The reset operation takes about 1 minute.
•
Do not turn off the camera during the reset operation.
•
If the camera is restarted, all sensor logs are deleted.
[For assistance, please call: 1-800-272-7033]
Operating Instructions
105