Huawei U9500 Maintenance Manual page 38

U9500 Maintenance Guide
4.Install the battery.
Attach the battery to the battery compartment
and place the cables in the compartment.
Note：Ensure that the gaps between the
battery and the battery compartment are even.
Step 8 Install the coaxial cable.
Step 9 Install the side keys, speaker, and back cover assembly.
Issue 1.2 (2012-6-30)
Positioning
slot
The coaxial cable must be placed below the
positioning pin as you place the phone
upward.
1.Install the coaxial cable.
Connect the coaxial cable head to the cable
connector, place the cable into the positioning slot,
and connect the cable tail to the cable connector.
Note: Ensure the red end of the coaxial cable is
connected to the board as shown in the picture.
1.Install the side keys and
tear away the release
paper.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Use the press jig to attach the battery
5.
tightly to the phone main body.
Air pressure of the press jig: 0.3± 0.1
Mpa. Press time: 3s to 5s
2.Take a speaker and place
the speaker with its foots
pointing in the same direction
as the arrow.
8 Assembly Procedure
2.The correctly positioned coaxial
cable is shown the figure above.
Note: The coaxial cable must be
placed into the slot without tilts.
3.Install the speaker.
Note: Do not change the
speaker foot direction when
you install the speaker.
33