Wi-Fi Test; Voice Call Test - Huawei U9500 Maintenance Manual

Hide thumbs Also See for U9500:

Table of Contents

U9500 Maintenance Guide

10.3 Wi-Fi Test

To ensure that the phone is properly connected to the network, place the phone 15 meters far

from the access point and clear the obstacles between the phone and access point.

To start the test, perform the following steps:

Step 1 Set the access point properly, power the phone on, and place it within the transmission range

of the access point.

Step 2 Touch the menu key and select System settings > WLAN > On > Scan.

Step 3 After the phone find out the access point SSID, touch the SSID and enter the password to

connect to the network.

Step 4 Adjust the distance between the phone and access point to observe the changes of Wi-Fi

signal strength on the phone.

Step 5 When the network connection is normal, open the web browser and access and website to test

the network quality.

If no problems are found, exit the Wi-Fi test. If any problems are found, troubleshoot the

mobile phone or send it to an advanced service center for repair.

---End

To conduct a voice call test, perform the following steps:

Step 1 Install the USIM card.

Step 2 Press the Power key to power the phone on.

Step 3 In a normal network, check that the signal strength displayed on the LCD is normal.

Step 4 Make a call to a fixed-line phone, and check the voice quality during the call.

If no problems are found, exit the voice call test. If any problems are found, troubleshoot the

mobile phone or send it to an advanced service center for repair.

---End

Issue 1.2 (2012-6-30)

Huawei Proprietary and Confidential

10 Functional Test

Table of Contents