Huawei U9500 Maintenance Manual page 37

U9500 Maintenance Guide
Step 6 Install the PCBA and rear camera.
1.Fasten the receiver FPC BTB connector.
Connect the receiver FPC to the PCBA.
Before fastening the BTB connector,
check that the receiver is correctly
installed. Tear away the front camera
protectors on the front cover and front
camera itself.
4.Fasten the LCD FPC BTB connector and then the main
FPC BTB connector, and install the side keys.
Tear away the release paper on the LCD FPC and fasten
the LCD FPC BTB connector the PCBA. Tear away the
release paper on the main FPC and fasten the main FPC
BTB connector to the PCBA. Tear away the release paper
on the side key FPC and then attach the FPC to the PCBA
with aligning the FPC with the positioning protuberance.
Step 7 Install the battery.
1.Take a battery.
Take a battery and tear the two
pieces of release paper away
fromt the battery compartment.
Issue 1.2 (2012-6-30)
2.Secure the PCBA.
Insert the positioning pins on
the front cover assembly into
the PCBA and snap the upper
and bottom latches.
2.Install the battery connector – 1
Insert the two positioning
pertuberances on the battery
connector into the positioning slot.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
8 Assembly Procedure
3.Install the rear camera and attach the
water indicating label.
Attach the water indicating label within
the silkscreen area. Insert the front
camera into the positioning hole on the
PCBA and then fasten the BTB
connector.
Do not press the bent area of the LCD
FPC. Ensure that the LCD FPC is not
pre-bent.
3.Install the battery connector – 2
Flat the connector head.
32