Table of Contents
Advertisement
7. Check idle speed and reset if necessary. If a tachometer is available,
idle speed should be set to the specification found on page 9
"Specifications" of this manual.
WARNING
When carburetor adjustment is completed, the cutting attachment
should not move at idle, otherwise serious personal injury may
result.
LUBRICATION
Blades
Level 1.
Tools required: Clean rag, 25 or 50 mm (1 or 2 in.) medium bristle
paint brush
Parts Required: 20W Engine Oil (lubrication), 50-50 mixture of
kerosene and 20W oil (cleaning).
WARNING
Hedge Clipper Blades are very sharp. Wear gloves to protect
hands.
1.
Disconnect spark plug wire from spark plug.
2.
Brush loose debris from blade and coat both sides of blade with the
50-50 cleaning mixture.
3.
Allow cleaning mixture to soften the remaining gummy residue then
wipe it from the blade.
4.
Apply clean oil to the entire length of the blade. Be certain the
blade bolts are lubricated.
5.
Wipe excess oil from the blade before putting the unit back in
service.
DANGER
DANGER
H
C
EDGE
O
'
M
PERATOR
S
LIPPER
19
ANUAL
Advertisement
Table of Contents
