Table of Contents
Advertisement
IMPORTANT: Install glass door frame before installing glass
door.
INSTALLING DOOR FRAMES
1. Remove screws from smoke shelf (see Figure 36).
2. Mount top door frame and secure with screws removed in step 1.
3. Remove center ash refractory by pulling ring handle (see Figure
37).
4. Remove ash box.
5. Remove three screws located at front of firebox (see Figure 37).
6. Align bottom rail mounting holes with holes at front of firebox
and secure with screws removed in step 5.
7. Place ash box in place. Replace center ash refractory.
Figure 36 - Installing Top Door Frame
Bottom
Door
Rail
Ash Box
Center
Brick
Figure 37 - Installing Bottom Door Frame
18
GLASS DOOR INSTALLATION
Top Door
Frame
Smoke
Shelf
Screws
Ring
Handle
SuperiorFireplaces.us.com
INSTALLING GLASS DOORS
Spring clips have been installed but some adjustments may be
needed. If doors do not close properly or do not appear straight, see
Door Adjustment.
1. With bi-fold doors completely folded, insert bottom pivot pin into
pivot hole located near bottom corner of front face opening and
swing door to vertical position making sure top pins slide into
door track. Door is installed when top door pin snaps into spring
clip.
2. Repeat step 1 for remaining door.
If you find doors do not close properly or do not appear level or
straight, proceed with section on door adjustment,
Fold Door and
Slide Top Pins
Into Track
Figure 38 - Installing Bi-Fold Doors
DOOR ADJUSTMENT
Remove doors and slightly loosen lower pivot clips and upper spring
clips. Replace doors and fully close them. Use 1/8" shims (any mate-
rial) to level doors. Once proper setting is achieved, carefully open
doors enough so that you can access spring clips with a Phillips
screwdriver. Tighten screws. See Figure 39.
Figure 39 - Adjusting Bi-Fold Doors
Spring Clip
Insert Pin into
Spring Clip
Insert
Bottom Pivot
Pin into Hole
Pivot
Hole
126601-01_J
Hide quick links:
Advertisement
Table of Contents
