Mercedes-Benz SLS AMG Owner's Manual page 210

Tyre pressure of 180 kPa (1.8 bar/
26 psi) is reached
If the tyre pressure is at least 180 kPa
(1.8 bar/26 psi):
Press on/off switch ; on the tyre inflation
X
compressor to 0.
The tyre inflation compressor is switched
off.
Remove connector ? from the 12 V
X
socket.
Remove filler hose E from tyre valve G
X
and refit the dust protection cap. Screw the
valve cap onto the valve again.
Leave tyre sealant bottle : attached to
flange F.
Stow the TIREFIT kit in a safe and accessi-
X
ble place in the vehicle.
Pull away immediately.
X
! After use, excess TIREFIT may run out of
the filler hose. This could cause stains.
G WARNING
Do not exceed the maximum speed of
80 km/h.
The "max. 80 km/h" label must be affixed in
the driver's field of vision.
The vehicle's handling characteristics may be
affected.
Stop after driving for approximately ten
X
minutes and check the tyre pressure with
the tyre inflation compressor.
i
On tyres that are equipped with a tyre
pressure sensor (tyre pressure monitor),
the use of sealant can lead to error mes-
sages and incorrect displays. Therefore,
use pressure gauge B in the TIREFIT kit to
check and correct the tyre pressure.
G WARNING
If the tyre pressure is less than 130 kPa
(1.3 bar/20 psi), the tyre is too severely dam-
aged. Do not drive any further. Consult a
qualified specialist workshop which has the
necessary specialist knowledge and tools to
carry out the work required. Mercedes-Benz
recommends that you use a Mercedes-Benz
Service Centre for this purpose. In particular,
work relevant to safety or on safety-related
systems must be carried out at a qualified
specialist workshop.
Correct the tyre pressure if it is still at least
X
130 kPa (1.3 bar/20 psi) (for the values,
see the fuel filler flap).
To increase the tyre pressure: switch on
the tyre inflation compressor.
To reduce the tyre pressure: open
release screw C.
! The manufacturer does not guarantee
that all tyre damage can be repaired using
the TIREFIT kit, particularly in the case of
cuts and punctures with a diameter of more
than four millimetres or on the sidewall. The
manufacturer is not responsible for dam-
age caused by inappropriate use of the
TIREFIT kit.
Drive to the nearest workshop and have the
X
tyre changed there.
Have the tyre sealant bottle replaced as
X
soon as possible at a qualified specialist
workshop, e.g. at a Mercedes-Benz Service
Centre.
H Environmental note
Have the used tyre sealant bottle disposed of
professionally, e.g. at a Mercedes-Benz
Service Centre.
Have the TIREFIT kit replaced every four
X
years at a qualified specialist workshop,
e.g. a Mercedes-Benz Service Centre.
Flat tyre
207
Z