Cisco N540-FH-CSR-SYS Install Manual page 36

Connecting Timing Cables
The management Ethernet port provides out-of-band management, which enables you to use the Command
Line Interface (CLI) to manage the router by its IP address. This port uses a 10/100/1000 Ethernet connection
with an RJ-45 interface.
Note To prevent an IP address conflict, do not connect the management Ethernet port until the initial configuration
is complete.
To connect cables to the system management port, attach Category 5 cables directly to the RJ-45 receptacle
on the management Ethernet port.
Figure 37: Console Port
Note
To comply with GR-1089-CORE, the intra-building port(s) of the equipment must use shielded intra-building
cabling or wiring that is grounded at both ends.
1. Plug the cable directly into the RJ-45 receptacle.
2. Connect the network end of your RJ-45 cable to a switch, hub, repeater, or other external equipment.
Connecting Timing Cables
The following sections describe how to connect timing cables.
Connecting Cables to a GPS Interface
The following sections describe how to connect cables from the router to a GPS unit for input or output timing
of frequency:
Install the Device
36
Install the Device