Cisco N540-FH-CSR-SYS Install Manual page 31

Install the Device
Figure 33: Attach the AC Power Tie-and-Clip Cord
Note
These images are for only representation purposes. Certain variants of Cisco NCS 540 do not include a tie
for the power supply cord.
Activate an AC Power Supply Module
Perform the following procedure to activate an AC power supply:
Step 1
Plug the power cord into the power supply.
Step 2 Connect the other end of the power cord to an AC-input power source.
Step 3
Verify power supply operation by checking if the respective power supply front panel LED (PS0 or PS1) is green.
Step 4 If the LEDs indicate a power problem, see Troubleshooting for troubleshooting information.
Step 5
If you are also connecting a redundant AC power supply, repeat these steps for the second power source.
Note If you are connecting a redundant AC power supply, ensure that each power supply is connected to a separate
power source in order to prevent power loss in the event of a power failure.
Activate an AC Power Supply Module
Install the Device
31