Kohler K-3797 Installation And Care Manual page 46

Finished Wall
Bidet Water Gasket
Supply
Washer
(Optional)
7. Install the Bowl
NOTE: This step is easier when performed by two people.
Confirm the gasket on the inside of the inlet elbow has correctly
engaged with the inlet pipe.
Confirm the gasket on the inside of the outlet elbow has correctly
engaged with the outlet pipe.
NOTE: If your model has a bidet seat, align the bidet water supply
with the corresponding hole in the back of the bowl.
Carefully lift the bowl up and align the threaded rods and pipes
with the corresponding holes.
Slide the bowl onto the threaded rods, inlet pipe and outlet pipe.
Make sure the bowl fully engages the gaskets on the inlet and
outlet pipes.
Slide the bowl back until it makes contact with the wall.
Lift the bowl slightly and install the gaskets over the threaded
rods.
Install the washers and nuts and tighten with a socket wrench
and 3/4" socket.
1145594-2-C
Threaded Rod
Nut
10 Kohler Co.