Warning Indications - Sony DXC-D35H/D35PH Operating Instructions Manual

Warning Indications

If a fault occurs during operation, a warning is given
by the REC/TALLY and BATT indicators in the
viewfinder and the tally lamp lighting or flashing, and
also by warning indications on the viewfinder screen.
When you are using a DSR-1/1P or PVV-3/3P, the
Camera
REC/ BATT Viewfinder
TALLY indicator screen
indicator indication
and tally
lamp
— —
— —
— —
— —
— —
— —
BATT
11.0V
BATT
10.5V
Continuous Flashing once per second
Four beeps per second
For the warnings appearing in the viewfinder when a VTR is connected, see the section "Viewfinder Normal Indications" (page
54).
Warning indications
VTR
WARNING Display Warning tone
indicator window
RF
(during
recording
only)
(During
recording only)
SERVO
HUMID
(During
recording)
(During
playback,
rewind, or fast
forward)
SLACK
TAPE
(flashing,
(During
during
recording
recording
only) only)
TAPE
(flashing)
BATT
(flashing) (During
recording)
BATT
(flashing)
Flashing four times per second
One beep per second
WARNING indicator on the VTR also lights or
flashes, and warning indications appear in the display
window. There is also a warning tone in the earphone.
Fault VTR action
The video The VTR emits
heads are a warning tone
clogged, or when it detects
there is some head clogging.
other fault in
the recording
system.
The servo Recording
lock has continues, but
been lost. the recording
may not be
satisfactory.
There is Recording
condensation. continues, but
if the tape
sticks to the
drum,
recording
stops.
Playback,
rewind, or fast
forward stops.
The tape is
The operation
not wound
stops. (Refer
properly.
to the service
manual or
maintenance
manual.)
The tape is Operation
near the end.
continues.
The tape is at Recording,
the end. playback, and
fast forward all
stop.
The battery is Operation
almost continues.
exhausted.
The battery is Operation
exhausted. continues.
Continuous
What to do
Carry out head cleaning,
referring to the instruction
manual for the VTR. If the
problem persists after cleaning
the heads, disconnect the
power and consult your Sony
dealer.
Disconnect the power and
consult your Sony dealer. (The
SERVO indication may flash
momentarily when the tape
transport starts, but this does
not indicate a problem.)
Stop the tape transport. Wait
until the HUMID indication
does not appear when you
power the unit on.
Press the EJECT button to
eject the cassette. Close the
cassette compartment and
check that the top panel has
descended before powering
off. Then consult your Sony
dealer. (Do not attempt to
insert any cassette.)
Change the cassette if
necessary.
Change the cassette.
Change the battery when
possible.
Change the battery.
97
Appendix